posted
My new 2 gig computer is screamin', but I've been doing a bit of that myself getting everything dialed in.
Now my vinyl height is defaulting to 18.75" My Graphtec plotter seems to be configured just fine & works like normal except when I put in 24" material I could always cut up to about 22.5" (depending on where the friction feed rollers were placed)
Probably an easy setting adjustment, but I am not finding where to re-set that. Hope someone has that info to help me get some promised jobs out.
[ May 14, 2002, 06:45 PM: Message edited by: Doug Allan ]
posted
DOUG when you set up the plotter you have to tell it which plotter you have. if you tell it it is a fc5120-50 it will set the default to 18.5 if you tell it it is a fc3160-60 it will set it to 22.5 hope this helps
-------------------- Jimmy Chatham Chatham Signs 468 stark st Commerce, Ga 30529 Posts: 1766 | From: Commerce, GA, USA | Registered: Nov 1998
| IP: Logged |
Printer-friendly view of this topic