posted
I’m mostly retired but was wondering if it was possible to cut from coredraw 18
-------------------- Ernest Clark Dahlonega Sign Co. 101 Whispering Winds Dr Murrayville,Ga 30564 Been there, Done that, Probably do it again. Posts: 134 | From: Dahlonega,Ga. USA | Registered: Dec 1998
| IP: Logged |
posted
My experience was always limited to Roland cutters and it always depended more on the operating system and the model of the cutter rather than the version of Corel Draw. Usually there is no driver support for older cutters with newer operating systems.
-------------------- Dave Grundy retired in Chelem,Yucatan,Mexico/Hensall,Ontario,Canada 1-519-262-3651 Canada 011-52-1-999-102-2923 Mexico cell 1-226-785-8957 Canada/Mexico home
posted
Thanks Dave.Someone gave me a 28 “ USCutter.I have had a Roland cutter for years and a sign program Vinylmaster Pro for years but now retired.Just wanted to know if it was possible to cut fro coreldraw18. Good to see your still around.
-------------------- Ernest Clark Dahlonega Sign Co. 101 Whispering Winds Dr Murrayville,Ga 30564 Been there, Done that, Probably do it again. Posts: 134 | From: Dahlonega,Ga. USA | Registered: Dec 1998
| IP: Logged |
posted
Most cutters started out as pen plotters, so if a windows driver exists it should be possible to cut. IF the plotter can draw no reason it can not cut. Like OP used to say you need to use an outline.
[ December 20, 2018, 06:23 AM: Message edited by: Brian Dish ]
-------------------- Brian Vinyl Signs Pittsburgh, PA. Posts: 159 | From: Pgh., PA | Registered: Mar 2009
| IP: Logged |
posted
Thank you.Found it on line.Pretty simple.Guess my mind was a little slow.
-------------------- Ernest Clark Dahlonega Sign Co. 101 Whispering Winds Dr Murrayville,Ga 30564 Been there, Done that, Probably do it again. Posts: 134 | From: Dahlonega,Ga. USA | Registered: Dec 1998
| IP: Logged |
Printer-friendly view of this topic