posted
Just realized I've only ordered 1 pre-cut Lusterboard 1x8 when I needed two. Luckily I ordered an extra 4x8. I have no panel saw. (Lusterboard is like ½" Alumalite with a wood core) Can I do this with a circular saw? Any tips? Love....Jill
Posts: 8834 | From: Butler, PA, USA | Registered: Jan 2001
| IP: Logged |
posted
Jill, we swap blades to a metal cutting ,on our circular Skil, clamp straight edge as mentioned. should be about 1 1/4 inch-or about, from line or edge of the clamped straight edge.) the width of the "deck" to blade line. wear glasses ! ( we actually have a 6" wide 1/2 " scrap 8ft. lusterB. for this activity! )
FYI-you can......if you know your neighbor,you might have to yank off a 8 ft.piece of their horse boarding fence !...."dear".
fresh cut edge will also be a bit sharp,got nail file young lady ? you go sign-girl !
-------------------- mark zilliox mark z signs 8425 pushaw station rd. owings md. 20736 301-855-5407 thezs@earthlink.net http://www.markzsigns.com Posts: 348 | From: maryland | Registered: May 2003
| IP: Logged |
posted
it will cut fine with a plywood blade or a fine tooth carbide blade.
-------------------- Jimmy Chatham Chatham Signs 468 stark st Commerce, Ga 30529 Posts: 1766 | From: Commerce, GA, USA | Registered: Nov 1998
| IP: Logged |
![[Thanks]](graemlins/thanks.gif)
Printer-friendly view of this topic