posted
I have a Master Tiger series cutter and cut from Sign Go.I use to cut from Corel and signlab but am not able to now.Please advise me if you know how.Thanks Randy Campbell jcampbell1118@cogeco.ca
-------------------- Randall Campbell Randy's Graphics, 420 Fairfield N. Hamilton Ontario Canada Posts: 2857 | From: Hamilton Ontario Canada | Registered: Jan 2002
| IP: Logged |
posted
This is 'old' but I was told that any plotter named after a cat would likely be temperamental to get sorted out.
There is a big section on the UK Sign Forums, for the Creation P-cut plotters with similar issues - you may find some answers there as they seem to have a bit of a fan club in UK.
I did try to help a friend connect Corel to a Creation P-cut 4 or 5 years ago - and we got nowhere. He did eventually get it going, but he gave it away, as he found it too abnormal for his liking. He was a retired signie who thought he'd get back into it again briefly...
[ April 04, 2015, 07:43 PM: Message edited by: Ian Stewart-Koster ]
-------------------- "Stewey" on chat
"...there are no limits when you aim for perfection..." Jonathan Livingston Seagull Posts: 7014 | From: Highgrove via Toowoomba, Queensland, Australia | Registered: Dec 2002
| IP: Logged |