posted
I only occasionally use my gerber edge setup. Switched from using the advantage software to flexi 7.0 because of a bug in my advantage software. However using flexi, when contour cutting to Gerber GS15 plus, it cuts erratically. Sometimes completes half a metre then cuts in odd places. Other times after 30 seconds cutting, I get flashing lights and beeping on the plotter. Any help would be appreciated particularly if anyone is using this, admittedly old, setup. Possibly a problem with port settings. Would anyone have a similar setup and could give me their port settings
-------------------- Kevin Gaffney Artistik Signs Kinnegad County Westmeath Ireland 044-75187 kevingaffney@eircom.net Posts: 628 | From: Ireland | Registered: Oct 2003
| IP: Logged |
posted
I had a similar problem when I switched to Flexi- I couldn't figure it out...but mine was just a coincidence: the Theta belt was failing. You may want to check it. If you have noticed little plastic nubs laying about, that are the size of a pencil lead tip, that may be it. With that fixed it cuts true now. Still pauses for about 2 seconds every 15 seconds or so for an unknown reason, but cuts true at least.
-------------------- Phil Steffen, 29 Van Rensselaer St City of Saratoga Springs DPW Saratoga Springs NY 12866 Posts: 563 | From: beautiful Saratoga Springs NY | Registered: Aug 2001
| IP: Logged |
posted
Sorry- just read the port setting issue question. I'll check it when I get back to the shop this afternoon. I have the exact same set up.
-------------------- Phil Steffen, 29 Van Rensselaer St City of Saratoga Springs DPW Saratoga Springs NY 12866 Posts: 563 | From: beautiful Saratoga Springs NY | Registered: Aug 2001
| IP: Logged |
posted
Kevin- I'll email you shortly what I know and you can reply with any specific questions you want me to check.
-------------------- Phil Steffen, 29 Van Rensselaer St City of Saratoga Springs DPW Saratoga Springs NY 12866 Posts: 563 | From: beautiful Saratoga Springs NY | Registered: Aug 2001
| IP: Logged |