posted
My customer wants a 4' x 5' sign attached to a chain link fence. It is made with Alumalite. Any type of fastener that would be slick for doing this?
-------------------- Dave Sherby "Sandman" SherWood Sign & Graphic Design Crystal Falls, MI 49920 906-875-6201 sherwoodsign@sbcglobal.net Posts: 5396 | From: Crystal Falls, MI USA | Registered: Apr 1999
| IP: Logged |
posted
1" x 6" pieces of aluminum with a hole drilled in the middle. 3 across the top and 3 across the bottom. Use them on the other side of the chain link side like washers.
-------------------- Si Allen #562 La Mirada, CA. USA
(714) 521-4810
si.allen on Skype
siallen@dslextreme.com
"SignPainters do It with Longer Strokes!"
Never mess with your profile while in a drunken stupor!!!
Brushasaurus on Chat Posts: 8827 | From: La Mirada, CA, USA | Registered: Nov 1998
| IP: Logged |
posted
At the track we just use 3/8" or 1/2" wire ties,.... drill a 1/2" hole in each corner and zip tie them up in less than 4 minutes,...it works and the ties are strong enough to keep the redneks from stealing the signs and taking them home as souvenirs...we tried smaller ties and they tend to get cut with a pocket knife and the signs get gone,...
[ July 05, 2010, 07:19 PM: Message edited by: Tim Barrow ]
-------------------- fly low...timi/NC is, Tim Barrow Barrow Art Signs Winston-Salem,NC Posts: 2224 | From: Winston-Salem,NC,USA | Registered: Nov 1998
| IP: Logged |
![[For Your Information]](graemlins/fyi.gif)
Printer-friendly view of this topic