Went to use the plotter and nothing happens when I turn it on . The fan runs and the head raises up but setup light never comes on.
[ April 17, 2017, 01:03 PM: Message edited by: George Perkins ]
Posted by old paint (Member # 549) on :
the lever on the left side...........to lock rollers.......under the cover there is a small on/off switch. mine came lose a couple of times...when you take off the cover you will see the little black switch, that makes contact with a 1/2 round actuator that closes the switch.....the actuator piece is held on by a screw....may have worked lose.
Posted by George Perkins (Member # 156) on :
No visible switch on this one. My friend sent his old plotter to my son. It was a different model and the cover was off and some jumper wires in place. I'll have to get this one down off the shelf to where I can open it up and look around for a switch. If not no big deal. I only use it two or three times a year and I can sub that work out.
Posted by old paint (Member # 549) on :
[ April 17, 2017, 03:20 PM: Message edited by: old paint ]
Posted by George Perkins (Member # 156) on :
from the looks of the wiring I think this is a motherboard problem
Posted by old paint (Member # 549) on :
sam sanphiipano is closer to ya.....hes runnng a printer now.i know he has a couple older rolands......he ran em from a MAC...... he might have a spare.....
